Vocational Technology Education: AA Degree
The Vocational Technology Education program is designed for transfer to the Vocational Technology Education bachelor’s degree at Northern Arizona University (NAU). Students completing this degree will transfer 60–64 credits to NAU. Students planning to transfer to a university other than NAU should see an advisor. This degree results in an AGEC-A, which is transferable to all Arizona public universities. This is a Programs of Study articulated program. For more information click here .jpg)
The outcomes identified below define the knowledge and skill sets
that graduates of this program will possess at the end of their program of study.
• Comprehend the scientific principles used in vocational technology.
• Comprehend the use and relationship of liberal arts within vocational technology.
• Demonstrate a fundamental knowledge in construction drafting, design, and layout.
• Possess the appropriate skills and knowledge to enter into and succeed in upper division courses leading to a bachelor’s degree in vocational education.
Minimum credit hours required: 60
|
AGEC-A Requirements: 35 credit hours
See General Education Courses that can be used to satisfy AGEC requirements.
Composition (6)
ENG 101¹ College Composition I (3)
ENG 102¹ College Composition II (3)
Mathematics (5)
MAT 187¹ Pre-Calculus (5) or a higher course selected from the approved AGEC courses in the Mathematics category.
Arts/Humanities (6)
Courses from two or more disciplines must be selected from the approved General Education courses in the Arts/Humanities category.
Social/Behavioral Sciences (6)
POS 220¹ Arizona & National Constitution (3)
One more course not in Political Science from the approved General Education courses in the Social/Behavioral Sciences category.
Physical/Biological Sciences (8–9)
Select one chemistry and one physics course from the following:
CHM 130¹ Fundamental Chemistry (4)
CHM 151¹ General Chemistry I (5)
PHY 111¹ College Physics I (4)
or
Complete 8 credits of physics below:
PHY 111¹ College Physics I (4)
PHY 112¹ College Physics II (4)
General Education Options (4–6)²
Courses may be selected from the above categories or from the Options category. |
Degree Core Requirements: 25–27 credit hours
Required: 3 credit hours
EDU 200 Introduction to Education (3)
Electives: 22–24 credit hours
Choose any 22–24 elective credit hours of transferable courses as stated in the Course Equivalency Guide (available from an advisor or on the web at www.coconino.edu) that transfer to NAU as DEC(VTE) or equivalent from any of the following areas:
AUT Automotive
CRP Carpentry Apprenticeship
DFT Drafting
ELT Electronics
CTM Construction Technology Management
SMT Sheet Metal Technology
WLD Welding Technology
¹ Placement test and/or prerequisite required.
² 4-6 hours may be taken in the Options category as needed to complete the minimum 35 hours required for the AGEC.
|
|
|
This catalog was prepared on the basis of the best information available at the time of publication. All information is subject to change without notice, obligation, or liability.